THE END-GRAIN BOARD CALCULATOR

Start with the right length.

From rough lumber to perfectly square blocks. Work out your starting
strip length before the first cut.

Your board

in

Your actual thickness after jointing and planing.
Strip width will match this for square blocks.

in

How long you want your finished cutting board.

in

The height of your board after the grain is turned.

Cutting allowances ⌄
in
in
in

Extra length to square up both ends of the first glue-up.

Rough-stock rip planner ⌄
in
in
in
in

Cleanup is total width lost from both edges of each panel. Final strip rips use the saw kerf above. Measure your stock at its narrowest usable point.

Accepts decimals or fractions, like 1 1/4.
YOUR STARTING STRIP LENGTHCUT PLAN
26 3/4in

Cut each initial strip to at least this length.

Strip cross section1 1/4 × 1 1/4 in
Crosscut slices15 pieces
Crosscut thickness1 5/8 in
Includes saw kerf, flattening & end-trim allowances

A little perspective

THE GRAIN DOES THE TURNING.
01 Glue up your strips
26 3/4 in

Long grain · first glue-up

02 Crosscut & turn
18 in finished

End grain · final glue-up

Rip before you mill.

    Cut positions mark the near edge of the blade, measured from the same stock edge. Put the kerf on the far side of each mark. Allow extra cleanup for wane or a wandering bandsaw cut; use a straight reference edge.

    The math, not the mystery.

    Each crosscut slice adds one milled thickness to your board’s length. We round up to a whole slice, then account for every cut.

    A note from the shop

    6/4 is your rough lumber size, not your final thickness. Measure after milling for an accurate plan. Board width depends on how many strips you glue together — it won’t change their starting length.

    MEASURE TWICE. CUT ONCE.